![]() Click on the Storage tab, then click on Disk Utilityġ. Under USB HighSpeed Bus, click on USB DiskĦ. This includes Cell Cycle and Proliferation! Fig 1: The Cytometry Platforms Preferences panel Cell Cycle preferences allow setting of the default model that Cell Cycle nodes should be created with – Watson vs DJF.5. The two button at the top allow you to add a new range or delete an… Read more » Cytometry PlatformsįlowJo Preferences can store your preferred starting point for specialized platform analysis. Ranges are predefined for ease but are completely editable for customization. Ranges can be set in Preferences, under the Tools section. Ranges predefined and named minimal and maximum to automatically format statistics out of expected ranges in the table editor. Click ok in the confirmation dialog to confirm reset… Read more » Ranges Use the Reset button in the lower left hand corner to set the configuration file for FlowJo to its default settings. To reset Preferences to factory default: Open Preferences by clicking on the heart icon in the upper right corner of FlowJo. Close Tables Without Save: If checked, tables will be disposed upon closing without asking you to save…. Open After Saving: If checked, output file will be open after saved. ![]() Tables Export Format: Choose the output format used most and set it as the default. Select the Tables button in Preferences under Output to open the Tables specific preferences. Use Short File Name: Uses the file name as seen by the operating system for sample names Use Full Path and File: Used when resolving… Read more » Tables Sample Display Naming FCS Default: Uses the FCS standard identification keyword as the display name for samples in the workspace. Select the Workspace button in the Preferences tool to open the Workspace preferences. Default settings without samples: Once samples are loaded, the keyword… Read more » Workspace ![]() Drop down menu reads: Annotation in the default settings when the Workspace is empty, more keywords are available when data samples are loaded into the Workspace. When you add keyword combination, the file name is changed from the acquisition name to the keywords that you choose. Select the Preferences icon or the Shortcut Key:… Read more » Workspace Preference Keyword Drop Down Guide This document focuses on the Preferences panel. Usually preferences are set from the main Preferences panel. You can save default settings like the number of significant digits, linear or log scaling, and font sizes, among others. Preferences can be used to fine-tune FlowJo to your specific analysis habits. Similarly to batching gates in the workspace and batching plots in the Layout Editor, the Table Editor is setup for batching numbers such as summary statistics (mean, median, CV, etc.), gate frequencies, values of… Read more » Setting Your Preferences In FlowJo, batch analysis takes advantage of your computer’s processing power and follows an analysis template to analyze multiple sets of data. The Column Information dialog is shown below: This dialog’s functions are described below:… Read more » Batching in the Table Editor This can be accessed via the “Add Column” and “Edit Column” buttons or by double-clicking on any row in the Table Editor. The Table Editor includes an interface for fine-tuning the formatting and content of each column - the Column Information dialog. In each case you can name the column, define it as a control value, choose whether or not to display its… Read more » Table Column Information Get your statistics, keywords, and formulas into the Table Editor for processing! There are three types of columns you can create when you click the “Add Column” button in the Table Editor: Statistic, Keyword, and Formula columns. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |